Exterior sliding stacking door system - SFK25

• Each panel can be manufactured to maximum widths of 900mm and heights of 3000mm (limitations apply)
• Panels will stack inside or outside, left or right
• The panels of the system work individually and stacks to one side
• Top hung (suspended) system with a bottom guide track.
• Panels can move around angles of faceted and corner systems
• The single glass panel is available in 8mm or 10mm toughened glass manufactured to BS6206a.
• The SFK25 cannot be used as a primary external grade glazing system

References

    - Watch a video of the SFK25 in use on You Tube
    - RAL colour chart

The series of six diagrams below shows the opening process for an opening in three panel set of doors. Watch a video of the SFK25 in use on You Tube

• The SFK25 is manufactured to either open in or out
• Panels are set to stack either the left or right side
• Split systems either open and stack at a mid-point or at opposite ends
• Corner and faceted systems can be created
• Straight, split, corner and faceted sets can be joined for area surrounds

Each of the diagrams below show opening-in door sets with left side priority . For each there are
three other variations as the diagram to the right shows.

Straight sets

Split sets

Corner and faceted sets

SFK25 opening in vertical detail is shown

• The track can be recessed up to 30mm below the final finished floor level on the inside and outside
• Soft pile brush seals run along the inside and outside edge of the track and head
• If fully recessed drainage needs to be consider along the outside track edge in areas with water
• The systems is a suspended system
• The head track has an adjustable profile to aid levelling

  Technical details
  - Opening in
  - Opening out

Standard finishes

• Powder coating is available in any RAL colour to suit any style and taste
• Handles are supplied in brushed stainless steel
• Top track panel guide is supplied in grey or black depending on frame finish
• Brushes at the top and bottom of the panel are supplied light grey

Handle

• As standard the doors are furnished with a brushed stainless steel turn handle with wire operation
• A brushed stainless steel lever handle is available with PZ-locking
• The turn handle and lever handle controls the single pass-door panel only

Jamb detail

• As standard the SFK25 is not supplied with side jambs
• The standard detail provides a uninterrupted glass to wall detail
• Jamb profiles with additional angles can be supplied
• The additional angle profiles cover the glass to wall gap to provide improved weather protection